olidoc2000 Posted November 23, 2015 Share Posted November 23, 2015 Hi guys, I'm using saitek yoke with P3D V3 and my cessna keeps going left both on the ground and in the air although it is centered. I suspect a configuration issue but i don't know where to calibrate it. I have the correct drivers for my version of windows 7/64 bits. Any suggestion ? Thanks Link to comment Share on other sites More sharing options...
mallcott Posted November 24, 2015 Share Posted November 24, 2015 Hi guys, I'm using saitek yoke with P3D V3 and my cessna keeps going left both on the ground and in the air although it is centered. I suspect a configuration issue but i don't know where to calibrate it. I have the correct drivers for my version of windows 7/64 bits. Any suggestion ? Thanks How do you know it's a calibration issue? If it's consistent across all aircraft then it could be. If it's just the `Cessna` whichever that is, then chances are it's a CG (weight) or power (torque) effect. Suspicion isn't truth, until borne out by empirical evidence and fact. P3D is a professional level simulator, think about what information you actually need to supply to enable anyone to help you. Link to comment Share on other sites More sharing options...
mallcott Posted November 24, 2015 Share Posted November 24, 2015 Hi guys, I'm using saitek yoke with P3D V3 and my cessna keeps going left both on the ground and in the air although it is centered. I suspect a configuration issue but i don't know where to calibrate it. I have the correct drivers for my version of windows 7/64 bits. Any suggestion ? Thanks Also, please give the version numbers for the drivers. Most Saitek products work perfectly well without drivers, which are known to cause problems in some setups. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.