I’m hoping you can help me solve this problem! About two and half weeks ago I purchased the CH Pro Pedals USB to use with Windows XP, FS2002 PRO on a 1.6 Ghz, 256MB Ram machine. After reading how CH is plug and play I plugged in the beautiful sucker and began to fly. While flying straight and level I noticed immediately that the heading was drifting a few degrees every couple of seconds! Well, I went back to check that the realism setting of rudder drift was OFF. Further investigating, upon hitting slew, the plane is actually is rotating on it’s own. Now about a millimeter of opposite rudder is needed to stop this. I am fairly positive this is not supposed to happen and is rather aggravating. I haven’t used them at all this past couple weeks and CH Products tech support was 100% useless. I have calibrated in both Windows product calibration and even CH’s. My return policy is almost up and I would be extremely disappointed to have to give these up…anyone have a suggestion to stop the drifting? By the way, before getting the Pedals and Yoke, I had a Microsoft Sidewinder 2, and used the rudder in that. However, I am sure that I uninstalled the Sidewinder program…anyone? Please! Any help is GREATLY appreciated in advance!