Missing airport buildings

[Romeo_Tango]

Hi,
Honestly, I don't see how this is related to RXP530, but here goes.
I recently upgraded some hardware; CPU, Motherboard and Memory.
I went about re-installing all my Flight one purchases due to their software protection system. I did this even though my RXP530 seemed to be working fine.
My process was to first run the UN-install from control panel. re-boot, download the latest installer from the main RXP site. (downloaded with anti virus software disabled). With anti virus still off I ran the installer, supplying license key and password when requested. All went well.
I rebooted, and started FSX. Loaded up real air Duke. Low and behold the gauge appears in the panel as it should but when clicking on the magnifying glass to pop up the gauge nothing happened. I then observed that my airport structures were missing. I went to a number of different locations (payware and default airports), same thing, no buildings. Runways etc. all seem fine. The RXP530 seem to work okay.

I am using Vista 64bit with user control disabled.
Thanks in advance

[f16jockey_2]

Don't know what RXP530 is, to be honest.

Have you checked the FSX Scenery settings for "Scenery complexity" and "Autogen density" ? Both sliders should be at least set at "Normal", preferably higher to the right.

Wim

[Derbert55]

f16jockey is correct. You must have scenery complexity on at least normal or higher to see airport buildings.