Wilco/Feelthere Airbus Volume 1

[EssexFireRescue]

Fella's

This is doing my head in, tut.

Im using the CH yoke with singal throttle on the top. But with this add on, it seems that i have too use the keys (F1 F2 F3 F4) for the throttle, even though my ch yoke works on every other dam airliner i decide to fly.

Any idea's

[rjsagel]

Hello,

I use a different throttle system - the GOFLIGHT TQ-6.

I do not use their software for any of my addons. I also use the Wilco AB vol-1. In my case, the throttle settings I use for all of my axis controls are from FSUIPC (Registered Version). I went to this when I needed a lot of setup for my Majestic Dash 7 throttles (Have to set them to throttle 3 and 4 to make 1 and 2 work right?????)

Anyway - try using FSUIPC for your throttle controls and see if it helps.

Cheers,

Ron Sagel
NEAR KCHS

[wdscobie]

modeling the Abus throttle gates requires the user follow the recommended configuration (page 16). this is because the CHyoke does not have 'gates'.

what behavior are you experiencing ... you provide no description.

i use the CHyoke with no problems.

you can search the following Abus support forums -

http://www.iemit.com/forum/forum.asp?FORUM_ID=26

http://www.iemit.com/forum/forum.asp?FORUM_ID=27


and you can read/post in the following -

http://forum.iemit.com

after registration look for 'Unofficial technical discussion products developed by feelThere'.


--