Texture Problems with Aircraft and Scenery

[northwestair]

I recently went back to FS9 from FSX and now when I load my aircraft and Scenery my textures are on top of each other. When the aircraft is loaded and viewable you will see the wheel textures on the fuselage and the fuselage texture will end up on the wing. Then when I do a right click on the mouse then the textures will reverse and the fuselage textures end up on the wing and then sometimes the textures will come out normal. I didn't have this problem with FSX or FS2002 , but only with FS9. I don't know what to do. I've played around with some of the display options in FS9, but to no luck.

[Au_Wozza]

Maaate that is so weird
Is it happening on all aircraft or an addon aircraft?
if it on all aircraft then it sounds like a video card driver issue
if its only happening on single aircraft its possible you have a wrong set of textures
or the texture folders are not installed correctly..... maybe a reinstall
cheers
Wozza

[northwestair]

It's happening on the Add on Aircrafts only and also the UT Traffic that I have. I just don't understand why it is only with FS2004 and not the FSX that I had.

[Au_Wozza]

Hi
Ok it looks like it "might" be an install problem
If you have texture's in the fs9/texture folder that has the same naming as an aircraft this will be used instead of the textures in the aircraft/texture folder.It could be a real pain going through and finding where the problem textures are or the missing folders have ended up I know been there done that normally a reinstall to a fresh copy of fs9,after uninstalling and deleting all the f9 folders is the easiest method
cheers
Wozza

[northwestair]

I did a complete uninstall and then reinstalled FS9, but I get the same thing everytime. I only have 1 add on Aircraft and that is a EMB135. What is weird is that when I do a right click that is when the texture becomes different. I think it has something to do with the graphic card and FS9 not reading it properly. I have a NVIDIA GEFORCE 7300LE.0 atlease that is what it says when I click Options and Display and then hardware while I'm in FS9. I guess I can always go back to FSX