I am designing a scenery using Airport 2.60 and am trying to alter the visual
ranges of my advanced buildings to no avail. I just can't stand the fact that
the buildings pop in and out at such small distances. I have tried to modify
the SCASM code as per some earlier posts to no avail. These earler posts were
from 1999 and suggested toying with the V1 and V2 values (even removing them).
This did not work for my buildings. Do these values only affect non-building
types?

Is there a way of doing this using the scasm code?

Finally,

I had set the visual range to max on my roads and polygons but these shapes
also pop in an out at ranges far below those I set. I am running FS2002 with
settings maxed out...


Thanks,

Pavlo
Dear Pavlo

try to set the "Detail level" option to dense or higher. That should help.

Fritz