Jet exhaust nozzles operate backwards_Help please

**WildBlue** · 07-04-2007, 07:02 AM

I'm referring to a FS2004 F-15 I downloaded from this site. The jet nozzles move to full open at idle and fully closed at max throttle. I can't find the gauge that controls the nozzles; that is, I can block out a gauge in the panel.cfg file that is linked to water rudder that, I believe was designed to control nozzle movement. But when I do, the nozzles still open and close.

If I could find the gauge, I could probably reverse the criteria.

Anyone have a clue for me?

Thanks.
WB

**bushp04** · 07-04-2007, 11:52 AM

Before getting into panels/gauges, could you switch airplanes to default Cessna and make sure your joystick throttle is operating properly?

There have been a number of times where mine got out of calibration for one reason or another, and I've seen anomalous behavior.

If, after operating the throttle on another plane you get the same behavior, try re-calibrating the joystick to make sure the Z axis goes full open when you push the throttles open, then moves to full closed when you draw the throttles to idle?

If problem still exists after calibration, then move on to panel/gauges.

Hope this helps,