DF727nj4.gauge

**ST667** · 03-13-2005, 06:18 AM

Hello....

this is my second Post for the same Problem.

after start the apu (in cold & dark) switch the "BUS TIE Circuit Open" Switch from Engine 3 to close and then the FS9 hang up with this Error Report.

AppName: fs9.exe AppVer: 9.1.0.40901 ModName: df727nj4.gau
ModVer: 1.0.0.0 Offset: 00007225

At now i will start with running engines , but this is boring.

I hope sombody can help me.

XP Home + SP2 Up to Date !
P4 2,8 FSB 800 , MSI 865PE Neo2-V (Last Driver), 1GB Kingston PC 400 Dual Channel , Club3D 9800er Pro with 5.2 Catalyst , DirectX 9.0c , FS9 and FSInn.

**kjbs** · 03-13-2005, 08:53 AM

Hello,

Have you tried to re-install your 727? It sounds like one of your files may have gotten corrupted. I am not an official support person, but if you uninstall your 727, and re-install using the GA727setup.exe in your Flight One Software folder, maybe it will be fine. Make sure all your anti-virus software is turned off during install. Hope this helps.

Kirby

**ToddNicholson** · 03-13-2005, 10:48 AM

Hi. Yes, I would suggest reinstalling the 727. It will likely fix your issue, as something has probably gotten corrupted. I did a search of the forums and you seem to be the only one with this issue, so I'm sure that it is something specific to your system and that a reinstall would likely solve it. Let us know what happens.

**ST667** · 03-14-2005, 02:46 AM

IT WORKS !!!!

Thanks for quick help.

greetings

ST667_Jörg

**ToddNicholson** · 03-14-2005, 09:53 AM

Glad the reinstall has fixed it for you:)

**ST667** · 03-16-2005, 07:20 AM

hmmm.... two Flights later , same Problem.

Jörg_ST667

**skeating** · 03-22-2005, 10:59 AM

Jorg
Just a long shot but if I were you I'd leave the BTBs closed at all times, these IRL would only be opened in an abnormal situation.
The only switches that should be open on the electrical panel on a cold and dark start are the GBs.

Unfortunately the config manager doesn't reflect this. Maybe it could be ammended in the upcoming service release to more accurately resemble real world proceedures and also make life a little easier for us operators.

Steve

**EDFM** · 03-22-2005, 11:14 AM

Steve,

you might be right about the real world procedures, but it should be at least solved in the update that FS is not crashing down if you use them.

**skeating** · 03-22-2005, 11:41 AM

Matthias

You are quite correct but as I have never opened them, only closed them on before start set up I'm afraid I can't confirm if they cause a program crash.

If it's true then I'm sure it will be fixed.
As I said it's just along shot

Steve