Jump to content

Stewie

Registered Users
  • Posts

    81
  • Joined

Stewie's Achievements

Community Guru

Community Guru (4/7)

  • First Post Rare
  • Collaborator Rare
  • Conversation Starter Rare
  • Week One Done
  • One Month Later

Recent Badges

10

Reputation

  1. Does anyone know where I can find an AI repaint in the new livery?
  2. Thanks crazy. If you figure that out, please let me know. When I try to connect to Real-World Weather, I receive the following error message. An error occurred while downloading Real-World Weather. Please check your internet connection and configuration and try again. Never had to do anything before. No idea how to resolve it.
  3. That's great! Thanks for letting me know. Not sure, why I keep getting that it's not connected to the internet, so It won't work for me and I unfortunately don't have a back
  4. Thanks. Will try and let you know the results.
  5. Thank you for the reply Luke. That being the case, how can I correct the joystick if recalibrating it does not work?
  6. Larry, Thank you for responding, however, FSUIPC is impacting the rudder and direction the plane veers while taxing, taking off, and flying without autopilot being activated.
  7. I have the Logitech Extreme 3D Pro Precision Joystick. For whatever reason, it doesn't seem to get along well with FSUIPC. Any aircraft I select to fly, I noticed the plane would turn to the left or right while taxing. I forgot all about FSUIPC and was solely concentrating on recalibrating the joystick. However, when I checked FSUIPC, I noticed that the rudder was not set to 0 (see below). How can I change this so the rudder sits in the right position, so while taxiing or flying without AP, the plane will not automatically bank left or right?
  8. Terry - For some reason, my FS9 would not connect to the internet so I could not download real weather. I tried asking for assistance, but like you, I could not find a resolution and no one else could as well. The resolution for me was to purchase FS Global Real Weather, which has worked remarkably well. Hope this helps. Stewie
  9. Thanks Tom! Truly appreciate you my friend.
  10. Roger - Sent a PM. Couldn't figure out how to get the email address. Thanks a million for doing this for me.
  11. Dedl - Thank you for responding. Not sure how to use ADE. I have discovered though, that the house sits at the exact location as the Airport Reference Point. Not sure if I move the reference point on the Afcad if that would move the house.
  12. Roger - Thank you so much for assisting. Here's the information requested...I hope. Exact Position - Using Afcad it shows N47*27.4917' E8*32.8800' 333.3* (same as the Airport Reference Point) Runway - Reciprocal End 34 Base End 16 Surface - Concrete Width 262 Length 12287 Pattern Alt 5000.0 Elevation 1416.0 Is it possible if I move the Airport Reference Point that would move the house?
  13. A picture of this dilemma has been attached. I'm hoping that there is a fellow FS2004 Simmer that has had this issue and was able to successfully resolve it. Unfortunately, I've searched google and found others that have experienced this issue, but no solution. Also, Aerosoft Forum has yielded no support. I have uninstalled and reinstalled the software, as well as, adjusting the scenery level to no avail. Not sure what else to do. Any support is greatly appreciated! Stewie
  14. Stewie

    Kias 0.0

    I changed panels so that I would have access to turning on Pilot Heat and when KIAS went to 0.00, I turned it on and it worked. Thank you so very much!
×
×
  • Create New...