sanyok
03-05-2005, 08:08 PM
I could not registern into their support forum (and if it didn't work the first time, I won't bother contacting admin and go any farther)
ok, those who have it (experienced simmers), you should be able to help me. I bought the item last week, studied the manuals through out the week, and today I was going to execute a first flight. Three small questions:
1. there's no option in aircraft config manager to load as cold and dark. I load a default Cessna, shut down the battery and engines, then load the 767. But the thing loads with electical power on and it loads with some kind of problems of unknown origin... What the duce?!
2. see my after-start configuration in the picture below:
http://www.flightsim.com/dcforum/User_files/422a5471645a7c5f.jpg
ok, my problem is when I shut off the APU after the engine start, I have no electrical power and the warning alarm goes on. I did everything as per the Normal Procedures (from the manual).
I have a "generator drive disconnect switch" light on (see above), is this part of the problem? I can't do nothing about it, it doesn't react to clicking. What to do?
3. FMS. I've read about it, a typical procedure as for most other FMSes, but I don't want to program the lateral part (waypoints) manually, I want to import the Company Flightplan. What is the story with a module (or something) that would allow me to export FSNav flightplans into Level D flightplan format?
The only option I see is to enter the whole thing manually. I enjoy programing the vertical part and weights, and that is as far as I want to go. So what's the story there?
ok, those who have it (experienced simmers), you should be able to help me. I bought the item last week, studied the manuals through out the week, and today I was going to execute a first flight. Three small questions:
1. there's no option in aircraft config manager to load as cold and dark. I load a default Cessna, shut down the battery and engines, then load the 767. But the thing loads with electical power on and it loads with some kind of problems of unknown origin... What the duce?!
2. see my after-start configuration in the picture below:
http://www.flightsim.com/dcforum/User_files/422a5471645a7c5f.jpg
ok, my problem is when I shut off the APU after the engine start, I have no electrical power and the warning alarm goes on. I did everything as per the Normal Procedures (from the manual).
I have a "generator drive disconnect switch" light on (see above), is this part of the problem? I can't do nothing about it, it doesn't react to clicking. What to do?
3. FMS. I've read about it, a typical procedure as for most other FMSes, but I don't want to program the lateral part (waypoints) manually, I want to import the Company Flightplan. What is the story with a module (or something) that would allow me to export FSNav flightplans into Level D flightplan format?
The only option I see is to enter the whole thing manually. I enjoy programing the vertical part and weights, and that is as far as I want to go. So what's the story there?