fjpetri
05-27-2001, 02:32 PM
Any suggestions relating to the scale of an aircraft. I have attempted
numerous times to create a large fuselage in the side view, Z axis, using the
Tube either as a single unit or in part sections . I save the parts etc. The
craft looks fine in the FS perspective view. However when I install the craft
in FS2k I get a pile of "junk".Is their a limitation on the Scale of an object
in the Z axis mode?
I have tried using templates, extruding from the fron view and various other
ways without success. I am able to build a fine looking model in FS Design Shop
but for some reason I cannot get it to display properly in FS2K.
Any advice is extremely appreciated.
fjpetri@earthlink.net
numerous times to create a large fuselage in the side view, Z axis, using the
Tube either as a single unit or in part sections . I save the parts etc. The
craft looks fine in the FS perspective view. However when I install the craft
in FS2k I get a pile of "junk".Is their a limitation on the Scale of an object
in the Z axis mode?
I have tried using templates, extruding from the fron view and various other
ways without success. I am able to build a fine looking model in FS Design Shop
but for some reason I cannot get it to display properly in FS2K.
Any advice is extremely appreciated.
fjpetri@earthlink.net