Beech A36 Altitude Selector only in 1K increments

[pasca333]

I have had this happen before and cannot remember how to correct it. The altitude selector in the autopilot will only increase or decrease in one thousand feet degrees. I can't select 1200 feet; only 1000 or 2000 feet.

What am I not remembering to do?

Many thanks.

[nojwod]

if you're using trackir you need to disable it when adjusting instruments

[pasca333]

Thank you for the answer. What is trakir? I've looked through the OM and cannot find a reference.

[ToddNicholson]

If you don't know what TrackIR is, you likely don't have it installed :D It's not part of the A36 installation - it's an addon for VC use.

As for the control acelleration, usually a reboot will fix it. If it is a continued problem on your system, you can use the "Fix Control Acelleration" option in the registered version of FSUIPC to fix it for good.

BTW - this is an issue related to FS, not the A36 in particular ;-)

[pasca333]

Thank you. I just tested it and now the altitude control works as it should in 100 feet increments. I have no idea what I did to correct it.

[ToddNicholson]

Glad to hear it's working for you now :)