View Full Version : Thrust reverser conversion
12-31-2005, 01:51 PM
It states clearly in the manual that the modelled version of the Super 27 has had its #2 reverser removed. Therefore, I was surprised to find that the airplane itself has a fully operational reverser on all three engines! Why is this? Perhaps it is not possible in FS to simulate only one engine without a reverser, so you have compensated by cutting the total effectiveness of the reversers by a third or so. If this is the case, please tell me so, and I will be much relieved.
12-31-2005, 02:05 PM
Well, yes, the model has the reverser removed, the effectiveness of the 1&3 reversers is acurate, the no.2 handles are removed. However, FS only allows identical engines and this poses a problem with the engine gauges using reverse. Obviously, in normal Pilot or FO view, you can't see the no.2 engine gauges, so this shouldn't detract from your enjoyment.
12-31-2005, 02:24 PM
Ok, well is the TOTAL amount of reverse thrust effectiveness accurate? That's the only thing I'm concerned about.
12-31-2005, 03:07 PM
[font size=1][font color=blue]Can you pilot a plane, instead of programming an FMC to do it for you?[/font color= blue][/font size=1]
12-31-2005, 03:16 PM
Jeremy, you worry too much. :)
Powered by vBulletin® Version 4.2.0 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.