PDA

View Full Version : Small error in Peter McLeland's Turbo Engine Change for the A36



petermcleland
12-01-2005, 08:10 PM
Lou and users of the LittleBanditTurbo kit please note there is a small error in the Aircraft.cfg file which gives wrong smoke trails on the "I" key press...Don't know how it got corrupted but it has been corrected now...Please download the file again (It is very small and just replace the Aircraft.cfg file) or alternatively make this small correction to the last item in the file:-

[SMOKESYSTEM]
smoke.0=0.40, -12.00, -15.0, fx_banditsmoke_red
smoke.1=0.40, -4.00, -1.0, fx_banditsmoke_white
smoke.2=0.40, -4.00, 3.0, fx_banditsmoke_white
smoke.3=0.40, -12.00, 17.0, fx_banditsmoke_red

Lou...Please could you re-download and change the file on your site...sorry for the trouble.

While we are on the smoke subject...some users are not seeing the startup flame and smoke from the exhaust pipes...This is because the aircraft has not been correctly loaded. You must go to the Default Cessna at Tacoma Flight and then load your A36 Tip Tank Version. The smoke and flame effect will now work. Now you must take it where you want it and SAVE the flight...The startup effect will now always work from that saved flight and any other saved flight derived from it. However...if you do further mods and the effect ceases to work then you will have to repeat the procedure :)

Lou_Betti
12-02-2005, 01:40 AM
No problemo, mi amigo, but wasn't there something else that needed to be changed, based on you using an early version of the A36 for the mod?

I cannot remember what it was. ;-)

Regards,
[link:www.dreamfleet2000.com|http://www.dreamfleet2000.com/gfx2/forum_banners/LOU.gif]
[font size=1][font color=blue]Can you pilot a plane, instead of programming an FMC to do it for you?[/font color= blue][/font size=1]

petermcleland
12-02-2005, 07:30 AM
>No problemo, mi amigo, but wasn't there something else that
>needed to be changed, based on you using an early version of
>the A36 for the mod?
>
>I cannot remember what it was. ;-)
>

OK Lou...hold off on that download...I have now changed the Texture name in the Aircraft.cfg and updated the .air file to the v2.5 plus my mods. Those were the the things you couldn't remember :) I'm just going to airtest and if satisfactory will upload the corrections. I will advise here when the corrected download is available.

Lou_Betti
12-02-2005, 09:44 AM
Yes, that was it!

Please give me the download link, Peter, once you have the changes completed and tested, and I will just download the whole package and re-post it. :-)

Regards,
[link:www.dreamfleet2000.com|http://www.dreamfleet2000.com/gfx2/forum_banners/LOU.gif]
[font size=1][font color=blue]Can you pilot a plane, instead of programming an FMC to do it for you?[/font color= blue][/font size=1]