Automaticwings
11-03-2001, 09:32 AM
I am sure most of you have run into the problem with the airport 2.60 water in Fs2002,
In my 2002 I download Barry Blaisdial's twin otter seaplane for Fs2002. When I place it in a 2.60 scenery in start up on 2.60 created water it will not move or take off just sits there.
This aircraft works perfectly in default water.
The Cessna default amphibian will take off of this water with the wheels down like it was on land. Then when you land it on the same water it lands OK. Even the floats sink into the water, but when it stops will not move, can't take off again.
I have the canuck 80 seaplane for Fs2002 installed. It is the only one that will take off and land, and then take off again on the 2.60 water. The pontoons ride on top of the water, and we get dust instead of a wake, but at least I can use it on the airport water.
Question, Is this going to be a problem Tom can fix with Airport 2.60, or is it a problem to be resolved with the aircraft designers?
Any similar problems, or comments appreciated.
Robert Palmer
In my 2002 I download Barry Blaisdial's twin otter seaplane for Fs2002. When I place it in a 2.60 scenery in start up on 2.60 created water it will not move or take off just sits there.
This aircraft works perfectly in default water.
The Cessna default amphibian will take off of this water with the wheels down like it was on land. Then when you land it on the same water it lands OK. Even the floats sink into the water, but when it stops will not move, can't take off again.
I have the canuck 80 seaplane for Fs2002 installed. It is the only one that will take off and land, and then take off again on the 2.60 water. The pontoons ride on top of the water, and we get dust instead of a wake, but at least I can use it on the airport water.
Question, Is this going to be a problem Tom can fix with Airport 2.60, or is it a problem to be resolved with the aircraft designers?
Any similar problems, or comments appreciated.
Robert Palmer