jlwoodward
02-02-2002, 03:24 PM
I am recently getting some bizarre behavior using Eddie Denneys Alaska mesh (2000 version) with FS2002. It has been working ok except at this location.
If someone could take the trouble, please go to Summit Lake (52Z) and advise if the lake is surrounded by low mountains, as it is supposed to be, or is deep in a canyon. I went back to the default mesh and it is ok then. I would like to find out if I have a problem with my setup, or if there is a glitch in the mesh.
The terrain mesh is located below my other Alaska sceneries, and the sliders are at default. Perhaps I should bite the bullet and download the 2002 version?
Thanks for any help,
John Woodward
If someone could take the trouble, please go to Summit Lake (52Z) and advise if the lake is surrounded by low mountains, as it is supposed to be, or is deep in a canyon. I went back to the default mesh and it is ok then. I would like to find out if I have a problem with my setup, or if there is a glitch in the mesh.
The terrain mesh is located below my other Alaska sceneries, and the sliders are at default. Perhaps I should bite the bullet and download the 2002 version?
Thanks for any help,
John Woodward